Wilton A5816 Instructions d'exploitation télécharger pdf (Page 13)

13

Electrical

115 Volt Operation

Referring to Figure 11:

As received from the factory, your drill press is

ready to run at 115-volt operation. This drill

press, when wired for 115 volt, is intended for

use on a circuit that has an outlet and a plug that

looks like the one illustrated in (A). A temporary

adapter, which looks like the adapter shown in

(B), may be used to connect this plug to a two-

pole receptacle if a properly grounded outlet is

not available. The temporary adapter should

only be used until a properly grounded outlet

can be installed by a qualified electrician. The

green colored rigid ear, lug, or tab, extending

from the adapter, must be connected to a

permanent ground such as a properly grounded

outlet box.

A

B

Figure 11

230 Volt Operation

Referring to Figure 12:

If 230V, single-phase operation is desired, the

following instructions must be followed:

1. Disconnect the machine from the power

source.

2. The JET drill press motor has four

numbered leads that are factory connected

for 115V operation, as shown in (A). For

230V operation reconnect the leads as

shown in (B).

3. The 115V attachment plug (C), supplied with

the drill press, must be replaced with a UL

listed plug suitable for 230V operation (D).

Contact your local Authorized JET Service

Center or qualified electrician for proper

procedures to install the plug. The drill

press must comply with all local and national

codes after the 230-volt plug is installed.

4. The drill press with a 230-volt plug should

only be connected to an outlet having the

same configuration as shown in (D). No

adapter is available nor should be used with

the 230-volt plug.

Figure 12

Permanently Connected Tools

Models J-A3816, J-A5816 and J-A5818 drill

presses that are intended for permanent

connection should be connected to a grounded

metal permanent wiring system or to a system

having an equipment-grounding conductor.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Commentaires sur ces manuels

Pas de commentaire