Wilton A5816 Instructions d'exploitation télécharger pdf (Page 9)

4. Figure 4: Loosen (do not remove) the four

screws in the worm gear housing.

Figure 4

5. Figure 5: Place the rack against the column

and slide it down as far as it will go into the

slot in the table bracket. (Position the rack

with the longer flat area toward the top and

the short flat area toward the bottom.)

6. Figure 5: Slide the rack ring down onto the

top of the rack and tighten the set screw on

the rack ring.

Figure 5

7. Tighten the four screws in the worm gear

housing (shown in Figure 4).

8. Figure 6: Install the table raising handle and

tighten its set screw. Rotate the handle to

move the table up and down the column,

checking that movement is smooth and rack

has been correctly installed.

Figure 6

Cleaning

Clean off any protective grease with solvent.

After cleaning, lubricate the base, table, and

column with a light coating of medium weight

machine oil. Repeat at six months intervals.

Internal parts of the drill press are lubricated at

the factory. No further lubrication is required at

the time of installation.

Electrical Connection

Refer to the Wiring Diagram section for wiring

information. Connection to electrical power

should be made by a qualified electrician.

Observe local electrical codes when connecting

the machine.

The motor should be protected with a time delay

fuse or circuit breaker with an amperage rating

slightly higher than the full load current of the

motor.

Operating Controls

(Refer to Figure 7)

ON/OFF Switch

The ON/OFF switch is located at the front of the

drill head.

Speed Control Handwheel

To avoid damage to the

speed adjustment mechanism, the motor

must be oper-ating before attempting to

adjust the speed rate.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Wilton A5816 Instructions d'exploitation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Perceuses électriques Wilton A5816