Wilton A5816 Instructions d'exploitation télécharger pdf (Page 6)

Safety Instructions for Drill Presses

1. All work shall be secured using either clamps or

a vise to the drill press table. It is unsafe to use

your hands to hold any workpiece being drilled.

2. Drill press head and table shall be securely

locked to the column before operating the drill

press. This must always be checked prior to

starting the machine.

3. Always use the correct tooling. Tooling shall

always be maintained and properly sharpened.

All tooling must be run at the proper speeds and

feeds as they apply to the job. Use only

recommended accessories and follow those

manufacturer’s instructions pertaining to them.

Tooling shall be not be forced in to any

workpiece but fed according to the proper

specifications. Failure to follow these

instructions will not only ruin the tooling as well

as the machine, but can cause serious injury.

4. Never brush away any chips while the machine

is in operation. All clean up should be done

when the machine is stopped.

5. Keep hands in sight. Do not put hands or fingers

around, on, or below any rotating cutting tools.

Leather safety gloves should be used when

handling any sharp objects or cutting tools. See

Figure A.

6. Always wear protective eye wear when

operating, servicing or adjusting machinery.

Eyewear shall be impact resistant, protective

safety glasses with side shields complying with

ANSI Z87.1 specifications. Use of the eye wear

which does not comply with ANSI Z87.1

specifications could result in severe injury from

breakage of eye protection. See Figure B.

7. When drilling in material which causes dust, a

dust mask shall be worn.

8. Avoid contact with coolant, especially guarding

the eyes.

9. Non-slip footwear and safety shoes are

recommended. See Figure C.

10. Wear ear protectors (plugs or muffs) during

extended periods of operation. See Figure D.

A B C D

ON/OFF Switch Padlock

For Model Numbers A5816 and A5818

To avoid accidental starting by young children or

others not qualified to use the tool, the use of a

padlock is required.

1. Open the padlock (Fig E).

2. Insert the through hole in the switch cover.

3. Close the padlock (Fig F).

4. Place the key in a safe place.

Figure E Figure F

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Wilton A5816 Instructions d'exploitation Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Perceuses électriques Wilton A5816